And I am assuming OSHA will be assembling a SWAT TEAM about 90 seconds after I hit publish….
Introducing The Flesh Remover 2000
I bought that 8 inch Horror Fright Bench Grinder a couple weeks ago because the little 6 incher didn’t have enough OOMPH when I was using the wire wheel I put on it.
After I got the new one put together and mounted on a stand I took one of the wheels off and went to mount that 8 inch wire wheel on it.
No love.
I wound up taking the guard off completely because it rubbed so bad and then found out it was wildly out of balance.
So I wound up putting that thing all back together and commenced pondering my navel over the situation.
I got that wire wheel and the adapter from Old Chuck a few years back and it was already mounted on a small GE electric motor but the capacitor was bad so I had to grab the wheel and give it a spin to get the thing going.
I had taken the motor pictured off my old drill press that I gave away and had replaced anyway so it was just laying around. I got the steel from the scrap bins at work, paid good money for it and decided to build a stand, mount the motor and wheel and go to town.
I also have an 8 inch Scotch Brite wheel still in the wrapper that I am going to see if it will fit too.
That would be a handy sumbitch.
This kind of shit is why you will never see a Snowflake step foot in my garage.